Abstract
Loss allocation in electrical power transmission system has a significant role to play in the restructuring of electricity market since generator and demands are connected to the same network. There is the need for an efficient loss allocation scheme that could fit all market structures in different locations. This paper presents the effect of real power loss allocation on the transfer bus with zero injection power.
Three approaches- the postage stamp method (PS), proportional sharing principle (PSP) or flow tracing method and the Bus-wise loss allocation (BWLA) method were compared using appropriate mathematical notations for the development of a Hybridized real power loss allocation model.
The average values of the losses with the three methods –PS, PSP and BWLA were computed to obtain the hybridized real power loss allocation model. The effect of real power loss allocation on the transfer bus with zero injection power is then established.
The results of the work show that in PSB method, a loss of 3.0751MW was allocated to bus 1 as it contributes 142.608MW to other loads with the allocation of 1.8523MW to bus 2 with the contribution of 55MW to the other loads. In BWLA method a loss of 3.1412MW was allocated to bus 1 with its contribution of power flow to the other loads as 146.908MW while allocating a loss of 1.2381MW to bus 2 with its contribution of power flow to other loads as 58MW. In the PS method, the participants with more contributions get more benefits compared to participants with lesser contributions.
Though, network is taken into consideration in PSB, customers have no reasonable benefits as compared to the BWLA method compared to the other two approaches.
The total real power loss of 25.18MW for the 30 bus system was obtained by using PS. PSP and BWLA method. All the three methods, PS, PSB and BWLA allot zero loss to the transfer bus which has zero injection power. In PSB method, negative losses ( counter-flows) occur when number of buses increases and in BWLA method, negative losses (counter flows) never occur even though there is an increase in the number of buses.
Downloads
Most read articles by the same author(s)
- Ganiyu Adedayo Ajenikoko, Olakunle, Elijah Olabode, Optimal Power Flow with Reactive Power Compensation for Cost and Loss Minimization on Nigerian Power Grid System , International Journal of Science and Engineering Invention: Vol. 2 No. 12 (2016)
Similar Articles
- Sandoval Cuji Martha Matilde, Fajardo Arriaga Julia del RocÃo, Sandoval Cuji Mónica MarÃa, Zambrano Medranda Luis Amable, Diagnosis of Competitive Strategies of SMEs - Quevedo , International Journal of Science and Engineering Invention: Vol. 3 No. 08 (2017)
- M Neeharika, Prabhat Kumar Hensh, Estimation of Leakage Mass Flow Rate through Labyrinth Seal Using CFD Techniques , International Journal of Science and Engineering Invention: Vol. 3 No. 07 (2017)
- Kenil Shah, Mayur Rane, Dr. Vahid Emamian, Detection of Heart Defects using Electrocardiogram (ECG) , International Journal of Science and Engineering Invention: Vol. 4 No. 11 (2018)
- Marisol Betty Véliz Aguilar, Freddy Jeovanny Fares Vargas, Paula Marisol Plaza Zambrano, Ethical and Moral Values ​​in the Teaching Process - Learning in Higher Education , International Journal of Science and Engineering Invention: Vol. 3 No. 02 (2017)
- Oluyemi-Ayibiowu B. D., Fadugba O. G., Dr, The Stabilization of Lateritic Soil Using Coir Fiber as Natural Reinforcement , International Journal of Science and Engineering Invention: Vol. 5 No. 06 (2019)
- W. Nyaigoti Omwoyo, Mutinda F. Silas, Oyaro Nathan, Florence Oloo, Removal of Chromium and Cadmium Ions from Water Using Graphene Oxide and Sodium Graphene Oxide Nanocomposites , International Journal of Science and Engineering Invention: Vol. 2 No. 08 (2016)
- Akonye Enyioma Joseph, Udeh Promise Chukwuedozie, Ports Authority and Implementation of The National Policy In The International Trade Practices: Issues And Prospect In The 21st Century , International Journal of Science and Engineering Invention: Vol. 6 No. 04 (2020)
- Xu Peng, Wang Yingying, Tian Jianxin, Fan Dongdong, Gao Shuai, Preparation of Hydrated Calcium Silicate High Filler Ink and Study on Printing Suitability , International Journal of Science and Engineering Invention: Vol. 5 No. 09 (2019)
- Brijesh Bhavsar, Prof. Anurag Nema, Prof. Ketan Dhumal, Design and Development of Dual Purpose Gear Drive for Blister Machine Application , International Journal of Science and Engineering Invention: Vol. 2 No. 04 (2016)
- Rigoberto Pastor Sánchez Figueredo, Asdrubal Braulio GarcÃa DomÃnguez, Roberto Pérez RodrÃguez, Fausto Hernán Oviedo Fierro, Increase of the General Technological Yieldin the Securing of Gray Iron with Graphite Spheroidal for the Metódo of Spilled Vibratory , International Journal of Science and Engineering Invention: Vol. 2 No. 03 (2016)
You may also start an advanced similarity search for this article.
Copyrights & License

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.